EN 1011-2:2001/A1:2003

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Parent metal
6 Weldability factors
7 Handling of welding consumables
8 Weld details
9 Welds in holes or slots
10 Preparation of joint face
11 Alignment of butt welds before welding
12 Preheating
13 Tack welds
14 Temporary attachments
15 Heat input
16 Welding procedure specification
17 Identification
18 Inspection and testing
19 Correction of non-conforming welds
20 Correction of distortion
21 Post weld heat treatment
Annex A (informative) Possible detrimental phenomena
        resulting from welding of steels, not covered by
        other annexes
Annex B (informative) Guidance on joint detail design
        (when there is no application standard)
Annex C (informative) Avoidance of hydrogen cracking
        (also known as cold cracking)
Annex D (informative) Heat affected zone toughness and
        hardness
Annex E (informative) Avoidance of solidification
        cracking
Annex F (informative) Avoidance of lamellar tearing
Annex G (informative) References in the annexes
Bibliography

This European Standard gives guidance for manual, semi-mechanised, mechanised and automatic arc welding of ferritic steels(see clause 5), excluding ferritic stainless steels, in all product forms.