EN 286-1:1998/A2:2005

Foreword
1. Scope
2. Normative references
3. Definitions, symbols and units
    3.1 Definitions
    3.2 General symbols and units
4. Classification and certification procedures
5. Materials
    5.1 Main pressurized parts
    5.2 Accessories contributing towards the strength of
         vessels
    5.3 Non-pressurized parts
    5.4 Welding consumables
6. Design
    6.1 General
    6.2 Weld joint design
    6.3 Determination of wall thicknesses
    6.4 Calculation method
    6.5 Experimental method
    6.6 Access and inspection openings
    6.7 Drainage openings
    6.8 Supports
7. Fabrication
    7.1 Manufacturing and testing equipment
    7.2 Forming of ends and shell
    7.3 Typical connections of main body
    7.4 Welding
8. Qualification of welders and welding operators
9. Qualification of welding procedures
    9.1 General
    9.2 Additional requirements for steel vessels
    9.3 Existing welding procedures
10. Testing
    10.1 Calibration
    10.2 Vessels designed by calculation method
    10.3 Vessels designed by experimental method
    10.4 Testing records
    10.5 Pressure test
11. Instructions to accompany the vessel
12. Marking
Annex A (normative) - Verification
Annex B (normative) - Declaration of conformity - Surveillance
Annex C (normative) - Design and manufacturing schedules
Annex D (normative) - Type examination
Annex E (normative) - Content of the manufacturing record
Annex F (normative) - Test of the protection against corrosion
Annex G (informative) - Essential safety requirements
Annex H (normative) - Requirements for peaking

Addition of a new normative Annex, for the requirement for peaking, based upon the requirements currently set out in EN 13445-4:2002 (clause 5.4.4).